You are here

test tps

Examination: 2017 SUMMER
Que.No Question/Problem marks
Q 1 f )

Classify the cam

2

Q 1 g )

Define following terms with respect to cam and follower

2

Q 1 h )

What are the limitations of knife edge follower ?

2

Q 2 c )

Draw and explain in short, types of followers used in cam and follower.

4

Q 5 a )

A cam with 40 mm minimum diameter rotates in clockwise...........

8

Examination: 2016 SUMMER
Que.No Question/Problem marks
Q 1a)(ii)

Define (i) Pressure angle (ii) Pitch point related to cam.

2

Q 2 e )

Draw neat sketch of radial cam with follower and show on it (i) Base circle. (ii) Pitch point. (iii) Prime Circle. (iv) Cam profile

4

Q 3 f )

What are the different types of follower motion ? Also draw displacement diagram for uniform velocity.

4

Q 5 b )

Draw the profile of cam operating a roller reciprocating follower ..........

8

Examination: 2016 WINTER
Que.No Question/Problem marks
Q 1a)(iii)

State the advantages of roller follower over knife edge follower.

2

Q 2 d )

Explain with neat sketch different types of follower.

4

Q 3 a )

Discuss the following motion of the follower by drawing the displacement velocity and acceleration diagram.

4

Q 5 b )

Draw profile of cam to raise the valve with S.H.M. through 5cm..........

8

Q 6a)(i)

Define the following terms as applied to cam with neat sketch.

4

Examination: 2015 SUMMER
Que.No Question/Problem marks
Q 1a)(b)

Enlist the different type of follower motion.

2

Q 2 e )

Draw a neat sketch of radial cam with roller follower and show the following on it.........

4

Q 3 b )

Why roller follower is preferred over a knife follower ? State two advantages and application of roller follower.

4

Q 5 b )

Construct a cam profile with knife edge follower having an offset of 10 mm........

8

Examination: 2015 WINTER
Que.No Question/Problem marks
Q 1a)(ii)

State any two types of motion of the follower.

2

Q 2 e )

Define the following terms related to cams.

4

Q 3 f )

Give detailed classification of followers.

4

Q 5 b )

Problem : A cam is to give the following motion to a knife edged follower : (i) Outstroke during 60° of cam rotation. (ii) Dwell for the next 30° of cam rotation.............................

8