The central distance between two shaft is 4 m having two pulleys..........
Draw a neat sketch of radial cam with roller follower and show the following on it.........
Describe stepwise procedure for determination of velocity and acceleration by Klein’s construction with suitable data.
Steps in Klein’s construction :
Define linear velocity, angular velocity, absolute velocity and state the relation between linear velocity and angular velocity.
Explain with neat sketch working principle of Oldham’s coupling.
When the driving shaft A is rotated, the flange C (link 1) causes the intermediate piece (link 4) to rotate at the same angle through which the flange has rotated, and it further rotates the flange D (link 3) at the same angle and thus the shaft B rotates. Hence links 1, 3 and 4 have the same angular velocity at every instant. A little consideration will show that there is a sliding motion between the link 4 and each of the other links 1 and 3.
Differentiate machine and structure on any four points.
Compare cross belt drive and open belt drive on the basis of .........
Comparison between cross belt drive and open belt drive :
Explain working principle of clutch. State its location in transmission system of an automobile.
A friction clutch has its principal application in the transmission of power of shafts and machines, which must be started and stopped frequently. The force of friction is used to start the driven shaft from rest and gradually brings it up to the proper speed without excessive slipping of the friction surfaces. In automobiles, friction clutch is used to connect the engine to the driven shaft. In operating such a clutch, care should be taken so that the friction surfaces engage easily and gradually brings the driven shaft up to proper speed.
Define completely constrained motion and successfully constrained motion with neat sketch. State one example of each.
Why is balancing of rotating parts necessary for high speed engines ?
The high speed of engines and other machines is a common phenomenon now-a-days. It is, therefore, very essential that all the rotating and reciprocating parts should be completely balanced as far as possible. If these parts are not properly balanced, the dynamic forces are set up.
Pages
