Que.No | Question/Problem | marks |
---|---|---|
Q 5 c ) |
A leather belt is required to transmit 7.5 kW from a pulley........... |
8 |
Que.No | Question/Problem | marks |
---|---|---|
Q 5 c ) |
Two parallel shafts, connected by a crossed belt,..... |
8 |
Q 6 b ) |
A simple band brake shown in figure 2 is applied to a shaft carrying a flywheel of mass 250 kg.......... |
8 |
Q 6 c ) |
A conical pivot with angle of cone as 100.......... |
8 |
Que.No | Question/Problem | marks |
---|---|---|
Q 5 a ) |
In a slider crank mechanism the length of crank and connecting rod are 100mm .......... |
8 |
Q 5 c ) |
In a band and block brake shown in Fig....... |
8 |
Q 6 c ) |
Determine the power lost in a footstep bearing........... |
8 |
Que.No | Question/Problem | marks |
---|---|---|
Q 5 a ) |
In reciprocating engine the crank is 250 mm long and connecting rod is 1000 mm long. .......... |
8 |
Q 5 c ) |
A belt is required to transmit 10 kW from a motor running at 600 rpm......... |
8 |
Q 6 b ) |
A simple band brake is operated by lever 40 cm long....... |
8 |
Q 6 c ) |
An engine of a car has a single plate clutch developed maximum torque 147 N-m....... |
8 |
Que.No | Question/Problem | marks |
---|---|---|
Q 5 c ) |
Problem:Two parallel shafts whose centre line are 4.8 m apart, are connected by open belt drive. |
8 |
Q 6 b ) |
In a simple band brake, the band acts on the 3/4th of circumference of a drum of 450 mm diameter............. |
8 |
Q 6 c ) |
A single plate clutch with both sides effective has outer and inner diameters ....... |
8 |