Mechanical Engg Simple Notes ,Solved problems and Videos

Meter OUT Circuit A typical meter out circuit is shown in figure. Here the flow control valve is installed in the return line metering the fluid being discharged. In that way, this circuit also gives the control over the actuating speed. But this way of control offers altogether different characteristics to the circuit. Now, the circuit pressure has to overcome the load resistance and the pressure drop across the flow control valve. However, as the flow control valve is on the right side of the piston, the differential area will cause rise in the pressure.

When pilot signal of pressurized oil is used to control movement of poppet in the check valve, it is called as pilot operated check valve. It is used when no flow characteristics of the valve is desired only for a portion of the system cycle. Figure shows the pilot operated check valve. A pilot piston is introduced below moving poppet. This pilot piston can move up by introducing pilot signal. Working: In normal position there is no flow from (A) to (B) because the movable valve poppet has blocked the flow. Now pilot signal is given through port (C).

Counter Balance Valve It is basically a relief valve but it is used to set up a back pressure in a circuit to prevent load from falling. They are frequently employed in vertical presses, loaders, lift trucks and other machines that must maintain a particular position or hold a suspended load. In such applications, the counterbalance valve creates a back pressure to prevent the movement of piston rod of cylinder

Seal: The seal is an agent or element which prevents leakage of oil from hydraulic elements and protects the system from dust and dirt. Classification of seals based on shape:- a) ‘O’ Ring seal b) ‘V’ Ring seal c) U-packing seal d) T- ring seal e) Cup seal

Factors for seal selection: 1) Type of fluid used in system 2) Maximum temperature of system in working condition 3) Functional reliability expected 4) Cost of seal 5) Working pressure of system 6) Environmental condition

Various Types of Air Motors 1. Vane Motor 2. Gerotor Motor 3. Turbine Motor 4. Piston Motor Construction: It consists of simple Vane rotor which is having slots in which vanes (flat piece of steel) slides freely. The rotor is eccentrically located inside the stator housing. Working: When pressurized air comes in through inlet port, the pressure of air distributes equal in all directions. Since vane is sliding freely in slots of rotator, the vane comes in to way of pressurized air and air pushes the vanes so that rotor starts rotating with speed.

Working of hydraulic circuit for milling machine. Hydraulic circuit for milling machine is comparatively different from other circuits. Table movement of milling machine is required to be adjustable for different feeds for different type of work. Therefore for both strokes of the cylinder, on both ends of cylinder flow control valves are used. Another feature of this circuit is that there are two pumps 1. Main pump – low pressure high discharge 2.

1) Centreline mounting Centreline mounts are used to take care of thrust that can occur linearly or along a centreline with the cylinder. Proper alignment is essential to prevent compound stresses that may cause excessive friction and bending, as piston extends. Additional holding strength may be essential with long stroke cylinders. 2) Foot mounting It consists of mounting the cylinder with the help of side end lungs or side covers. These mountings are used where cylinders are to be mounted on to surface parallel to the axis of cylinder