Theory questions and answers on SPUR GEARS 

Q.1. State the applications of Gear drives?

Theory question and answers on Fluctuating Stresses

Q.1. What are the various factor that reduce fatigue strength of the material? What factors should be considered while designing against fatigue failure? How the endurance limit for a given component is obtained from the endurance limit from standard test?

Key Points to Remember 

• Belt transmission is comparatively simple, trouble free, easy to be serviced ,maintained and have relatively low initial cost.
• Belts can connect non-parallel shafts also.
• Belts do not have space constrain, lubrication or heating issues.
• Since belts are flexible matreial there is inbuit shock protection.
• Mainly belt drives are Flat belt drive and V- belt drive
• Flat belts although simple and economical they have relatively less grip and make more noise.

Key Points to remember

• A power screw is a device which is used to convert rotary motion into translatory motion and thereby transmitting power. Typical applications involve screw jack,fly press, C clamp,testing machines, lead screw of lathe machine and many other machine tool applications.

Shaft Coupling Design :Theory Questions and answers and Numerical problems

Shaft coupling design article containg design procedure and numerical problems of different types of couplings commonly used.

Shaft Design : Theory questions and numericals

Shaft design theory questions and answers : The theory questions on shaft design contain the various question and their answers related to shaft design.

Q.1. Distinguish Between Shaft, Axle and Spindle

Following table provides the difference

Bolted joints and welded joints

Bolted joints are mainly used as temporary fasteners, which can be connected or disconnected whenever required.

Mechanical engineering needs the components to be attached to each other temporarily or permanently for the functioning of the machine. Following are the three types of joints are used in mechanical engineering.

1) Welded joints,2) Riveted joints 3)Bolted joints

Design of levers 

Key points to remember regarding design of levers :

• the design of levers is all about finding the dimensions of the levers so that it could perform its function satisfactorily
• A lever is force multiplier, depending upon the location of the load and effort from the fulcrum point.
• Levers are classified on the basis of location of load, effort and fulcrum point.

Machine Design I

Design of Joints : Knuckle Joint, Cotter Joint and Turn Buckle

 The article contains the questions and answers related to the design of joints including knuckle joint, turn buckle and Cotter joint. It includes  the various applications of the joints and also the comparison of the joints.

Introduction to Machine Design

Introduction to machine design theory questions and answers.

Introduction to Machine Design chapter theory questions and answer are given below.

1) State the general design consideration in machine design.

General Considerations in Machine Design

      Following are the general considerations in designing a machine component :

      1. Type of load and stresses caused by the load.